2022 Kia Telluride Air Filter in Burlington, MA

The 2022 Kia Telluride’s engine air filter sits inside the airbox in the engine bay, typically on the driver-side near the intake duct.

This location allows the 3.8L V6 to draw filtered air before it reaches the throttle body. Access usually involves releasing a few clips or screws on the airbox cover. If you’re servicing your Telluride in Burlington, MA, our team can check the housing seal and intake snorkel for debris or gaps that let in unfiltered air.

• Airbox in engine bay; lid secured by clips/screws
• Upstream of the mass airflow (MAF) sensor and throttle body
• Quick visual check for leaves, sand, or damaged seals

The 2022 Kia Telluride’s cabin air filter is behind the glove box in the HVAC intake area.

To access it, the glove box is lowered by releasing the side damper and stops, revealing a small access panel. This filter cleans incoming air for the heater and A/C, reducing dust and allergens for passengers around Burlington and the greater Boston area.

• Located behind the glove box, in front of the blower motor
• Access panel slides out; note airflow direction arrows
• Good time to inspect for leaves or odor-causing debris

The engine air filter protects the 3.8L V6’s intake from dirt, while the cabin air filter cleans the air entering the passenger compartment through the HVAC system.

Both filters serve different systems: one safeguards combustion components, the other improves in-cabin air quality for you and your passengers. Keeping each clean helps preserve performance and comfort during daily driving in and around Burlington, MA.

• Engine filter: before throttle body/MAF; affects power and wear
• Cabin filter: in HVAC intake; affects airflow and odors
• Distinct locations, materials, and service procedures

Common signs include reduced acceleration, rough idle, and lower fuel economy for the engine filter, plus weak airflow or musty odors for the cabin filter.

On the 3.8L V6, a heavily loaded engine filter restricts intake flow, which can dull throttle response. In the cabin, dust and pollen accumulation hampers blower performance and may cause unpleasant smells. If you notice these symptoms near Burlington or greater Boston, it’s a smart time to have both filters inspected.

• Engine: sluggish power, higher throttle needed, possible MAF contamination
• Cabin: reduced vent airflow, foggy windows, earthy or musty scent
• Visible dirt or darkening on filter media

Yes, both filters are DIY-capable, but dealer service adds an intake/MAF inspection and confirmation of OEM-spec fitment.

The engine filter swap is typically straightforward; the cabin filter requires glove box release and careful orientation. At Herb Chambers Kia of Burlington, technicians confirm correct seal seating, check the housing, and verify airflow direction to avoid noise or leaks. Choose what fits your comfort level; either way, use the proper, model-specific filter.

• DIY friendly with basic tools and proper orientation
• Dealer checks: airbox seals, MAF condition, HVAC door function
• OEM-spec parts help maintain performance and fit

Yes—Herb Chambers Kia of Burlington installs Genuine Kia OEM-spec engine and cabin air filters.

Using Kia-spec components helps ensure proper filtration efficiency, fit, and seal integrity for your 3.8L V6 and HVAC system. OEM parts also align with Kia maintenance guidance and avoid issues caused by ill-fitting aftermarket filters.

• Genuine Kia filters for correct size, seal, and media
• Designed for the Telluride’s intake and HVAC flow rates
• Installed by Kia-trained technicians in Burlington, MA

Book online anytime using our schedule service tool at schedule service.

Choose a time that works, note engine or cabin filter concerns, and we’ll prepare OEM-spec parts for your visit. If you’re near Woburn, Waltham, Lexington, Bedford, Wilmington, Medford, or Malden, our Cambridge Street location is convenient.

• Schedule online in minutes: schedule service
• Check current offers: service specials
• Easy access from Route 3A, Route 3, and I-95/128

Yes—a clogged engine air filter can reduce performance and may lower fuel economy by restricting airflow.

The 3.8L V6 relies on consistent intake flow; excessive restriction forces the engine to work harder, which can affect efficiency. Keeping the cabin filter clean won’t change MPG, but it will improve HVAC airflow and comfort, especially during high-pollen seasons around the greater Boston area.

• Engine filter condition influences throttle response
• Cabin filter impacts airflow and defogging, not MPG
• Inspection helps spot debris that can reach the MAF

The 2022 Kia Telluride uses two filters: an engine air filter that protects the 3.8L V6 (291 hp, 262 lb-ft) from dirt ingestion, and a cabin air filter that cleans HVAC intake air for passengers. Genuine Kia OEM filters provide the correct dimensions, sealing surfaces, and filtration media for the Telluride’s intake and blower design. Follow the Kia maintenance schedule in your owner’s manual for interval guidance, and consider earlier inspection if you frequently drive on dusty roads or in heavy pollen. A proper seal in the airbox and correct airflow orientation in the HVAC housing help avoid noise, leaks, or reduced performance. Bring your 2022 Kia Telluride to Herb Chambers Kia of Burlington in Burlington for OEM-spec filter service — schedule service.

Our service includes inspection and replacement of the engine air filter and cabin air filter using Genuine Kia parts, plus checks that protect your Telluride’s 3.8L V6 and HVAC system. We verify the airbox condition, confirm proper seal seating, and perform a visual check of the intake tract and mass airflow (MAF) sensor. For the cabin filter, we lower the glove box, inspect the blower intake for debris, and install the filter with the correct airflow orientation. Parts are covered by Kia OEM parts warranty terms. Review current offers on our service specials page and schedule service when ready.

Herb Chambers Kia of Burlington serves Burlington, Woburn, Waltham, Lexington, Bedford, Wilmington, Medford, Malden, and the greater Boston area from our Cambridge Street (Route 3A) location. Local driving can expose filters to leaf litter, road grit, and seasonal pollen, which load media faster and can reduce engine performance or cabin airflow. During your visit, our Kia-trained technicians use OEM-spec filters and confirm proper installation to help maintain smooth throttle response and clean cabin air. We’re conveniently located near Route 3 and I-95/Route 128 for easy access. Have questions or ready to book? Use our online schedule service tool or check service specials before your appointment.